Correct seatpost clamp sizing

General cycling advice ( NOT technical ! )
belgiangoth
Posts: 1215
Joined: 29 Mar 2007, 4:10pm

Correct seatpost clamp sizing

Postby belgiangoth » 26 May 2019, 3:20pm

I need to replace a seatpost clamp. Am I correct in believing that they are sized by diameter? What is the tolerance?
If I had a baby elephant I would let it sleep in the garage in place of the car. If I had either a garage or a car. (I miss sigs about baby elephants)

PT1029
Posts: 646
Joined: 16 Apr 2012, 9:20pm

Re: Correct seatpost clamp sizing

Postby PT1029 » 26 May 2019, 7:17pm

If you are talking about the clamping collar where the seat post enters the frame, diameter is usually 28.6mm, 31.8 or 34 (or is it 34.something?) - the same as clamp on front gears (unless you have some tapered exotic something or other).
Seat posts come in 0.2mm diameter increments, the decimal point always being an even number*, these you need to get exact. (*Some Giants use 30.9mm diameter seat pins though).

Brucey
Posts: 34217
Joined: 4 Jan 2012, 6:25pm

Re: Correct seatpost clamp sizing

Postby Brucey » 27 May 2019, 12:22am

standard seat tube sizes are indeed

28.6mm (1-1/8")
31.8mm (1-1/4")
34.9mm (1-3/8")

but tolerances vary because
- not all clamps are made the same way
- not all clamps accept the same size seat pin inside the clamp
- not all frames use standard sized seat tube sizes at the top

on the last point tubes are often externally butted and this means that the ID of the seat binder collar may vary from the nominal diameter of the seat tube where the FD fits.

In short the clamp could need to be almost any size, so assume nothing, measure everything.

cheers
-------------------------------------------------------------------------------
~~~~~~~~~~~~~~~~~~~~~~Brucey~~~~~~~~~~~~~~~~~~~~~~~~