Nazca Fuego rack fitting

DIscuss anything relating to non-standard cycles and their equipment.
hercule
Posts: 921
Joined: 5 Feb 2011, 5:18pm

Nazca Fuego rack fitting

Postby hercule » 14 Oct 2018, 7:57pm

I’m trying to figure out how to fit the Fuego underseat rack - unfortunately the only instructions I can find are in Dutch and I’m worried I might miss something...

Specifically, it’s fitting the forward mounting point. I’m a bit worried that by undoing the bolts holding the aluminium plates that the whole bike will fall to bits! I presume I need a spacer on the left side, but what about on the right?

Enlightenment much appreciated!

User avatar
[XAP]Bob
Posts: 16847
Joined: 26 Sep 2008, 4:12pm

Re: Nazca Fuego rack fitting

Postby [XAP]Bob » 15 Oct 2018, 9:22am

Got any photos of the bike/fitting and/or scans of the destructions?
A shortcut has to be a challenge, otherwise it would just be the way. No situation is so dire that panic cannot make it worse.
There are two kinds of people in this world: those can extrapolate from incomplete data.

User avatar
squeaker
Posts: 3509
Joined: 12 Jan 2007, 11:43pm
Location: Bramber, West Sussex

Re: Nazca Fuego rack fitting

Postby squeaker » 15 Oct 2018, 9:59am

[XAP]Bob wrote:Got any photos of the bike/fitting and/or scans of the destructions?
Kit of parts shown here, if that helps?

hercule: you could always ask David Gardiner at Laidback.

Edit: just found a set of fitting instructions in English - see your PM
Last edited by squeaker on 15 Oct 2018, 10:38am, edited 1 time in total.
"42"

User avatar
squeaker
Posts: 3509
Joined: 12 Jan 2007, 11:43pm
Location: Bramber, West Sussex

Re: Nazca Fuego rack fitting

Postby squeaker » 15 Oct 2018, 10:03am

squeaker wrote:
[XAP]Bob wrote:Got any photos of the bike/fitting and/or scans of the destructions?
Kit of parts shown here, if that helps?

hercule: you could always ask David Gardiner at Laidback.

The attached might help too?
Image Attachments
SilverOSU.jpg
Silver OSR.jpg
"42"

hercule
Posts: 921
Joined: 5 Feb 2011, 5:18pm

Re: Nazca Fuego rack fitting

Postby hercule » 15 Oct 2018, 11:00am

Thanks squeaker - PM replied to!