SUGINO OX601D crankset question

For discussions about bikes and equipment.
GeorgeDR
Posts: 5
Joined: 7 Feb 2013, 1:50pm

SUGINO OX601D crankset question

Postby GeorgeDR » 21 Aug 2017, 3:52pm

Hello-I have a Sugino OX601D crankset that unfortunately is missing the left hand crank arm (lost in a shed clearing exercise!). I have done an internet search for spare parts but this particular part seems to be hard to get. My question is whether anybody knows if a Hollowtech II crank arm from Shimano would work as these are easily available. Many thanks.

Brucey
Posts: 35590
Joined: 4 Jan 2012, 6:25pm

Re: SUGINO OX601D crankset question

Postby Brucey » 21 Aug 2017, 4:20pm

Image

I think that the spline is different...?

cheers
-------------------------------------------------------------------------------
~~~~~~~~~~~~~~~~~~~~~~Brucey~~~~~~~~~~~~~~~~~~~~~~~~

scottg
Posts: 643
Joined: 10 Jan 2008, 8:44pm
Location: Highland Heights Kentucky,, USA

Re: SUGINO OX601D crankset question

Postby scottg » 21 Aug 2017, 8:43pm

The thin walled spindle OX601 cranks were recalled and replaced in 2015.
I had one break on me, the day after receiving the recall notice.
The replaced crank has been fine since then.

https://www.suginoltd.co.jp/replace/
+++++++++++++++++++++++++++++++++++++
Why not the best, buy Cyclo-Benelux.

Brucey
Posts: 35590
Joined: 4 Jan 2012, 6:25pm

Re: SUGINO OX601D crankset question

Postby Brucey » 21 Aug 2017, 9:37pm

the spline interface between the crank and the spindle is the same in any event, and it is rather different to the Shimano one.

FWIW I think the crank in the photo I posted upthread is the sort that has been recalled because it is liable to break. The sort that are OK have (I think) thicker walled spindles (without grooves in the end) and/or polished bearing mounting surfaces on the spindle.

A translation of the Japanese from the webpage reads (I think) as follows

A: Polished bearing surface, M15 or M18 'pusher', OK
B: Black bearing surface, M18 pusher, Recall
C: Black bearing surface, M15 pusher, groove on end of spindle, Recall
D: Black bearing surface, M15 pusher, no groove, OK.

cheers
-------------------------------------------------------------------------------
~~~~~~~~~~~~~~~~~~~~~~Brucey~~~~~~~~~~~~~~~~~~~~~~~~