OK, I have a steel framed bike (725) with a stuck ally seat post. I am preparing myself for a slow, steady, long hacksaw cut inside the ally post to release it. I have done this on a steel frame some years ago, but wonder if there is a quicker way of 'sensibly' removing the seat post.
The bike which is 2 years old has been in in a 'wet' shed for some time and the seat post is really stuck. I have applied GT85 to the post but it refuses to move. I imagine that a 725 steel frame tube is a lot thinner, so I must be very caerful?
Suggestions please
Seat post removal
-
- Posts: 323
- Joined: 12 May 2007, 7:05pm
- Location: Somewhere in Kent
Re: Seat post removal
Read this thread.
Re: Seat post removal
Rather than gt85 try a penetrating/releasing fluid such as Plusgas. Be prepared to take a few days, squirting some more in every day and giving it time to work
Richard M
Cardiff
Cardiff
Re: Seat post removal
Do you need to move it? If it's correct height for you I'd leave it be.Save a lot of hassle.
Re: Seat post removal
If the frame has brazed on seat bolt attachments it could be quite easy. If the frame uses a seat tujbe clamp, good luck with the cutting.
-
- Posts: 323
- Joined: 12 May 2007, 7:05pm
- Location: Somewhere in Kent
Re: Seat post removal
Thanks for all the replies.
Yes, there is a need to lower the seat a bit for safety as a childs seat is being installed via a seat tube bracket and those two prongy things, can't remember the name of it.
I will try the Plusgas route first and then ice cubes and hairdryer.
The last time I hacksawed a seat post it took forever, just to be careful.
Ke1th wrote:Do you need to move it? If it's correct height for you I'd leave it be.Save a lot of hassle.
Yes, there is a need to lower the seat a bit for safety as a childs seat is being installed via a seat tube bracket and those two prongy things, can't remember the name of it.
I will try the Plusgas route first and then ice cubes and hairdryer.
The last time I hacksawed a seat post it took forever, just to be careful.
-
- Posts: 1208
- Joined: 21 Jan 2007, 3:13pm
Re: Seat post removal
More hassle but if you strip the bottom bracket and put the bike upside down and introduce the plus gas from there you will stand more chance of the plus gas getting where it needs to to release the post. And have a look at the Sheldon Brown blog on this.
-
- Posts: 3436
- Joined: 10 Jul 2014, 1:12pm
- Location: Norfolk
Re: Seat post removal
you may be able to put it in (again with bike upturned) through bottle cage securing threads thus avoiding bb removal?
-
- Posts: 323
- Joined: 12 May 2007, 7:05pm
- Location: Somewhere in Kent
Re: Seat post removal
Yes, thanks for that. I will try the bottle cage threaded holes route and the BB as well as the Chainset is out already.