hollowtech II to square taper
Posted: 18 Oct 2018, 12:13pm
Hi
I am considering converting one of my bikes to electric assist -I've had a bit of a health issue. It seems the only way to get a sensor that will respond to my pedal pressure in the conversion is to swap my bottom bracket for a square taper. I can find a zillion articles on why and how to go from square taper to hollowtech but none on vice versa. Any tips and wrinkles? Is it even possible? The bike I'm thinking of converting is a Dawes Super Galaxy 2008. I expect I'll have to swap out the chainwheels too... should I expect to find the equivalent triple easily on a square taper? TIA for any advice
ps the masterplan is to eventually get fit enough to take it off again!
I am considering converting one of my bikes to electric assist -I've had a bit of a health issue. It seems the only way to get a sensor that will respond to my pedal pressure in the conversion is to swap my bottom bracket for a square taper. I can find a zillion articles on why and how to go from square taper to hollowtech but none on vice versa. Any tips and wrinkles? Is it even possible? The bike I'm thinking of converting is a Dawes Super Galaxy 2008. I expect I'll have to swap out the chainwheels too... should I expect to find the equivalent triple easily on a square taper? TIA for any advice
ps the masterplan is to eventually get fit enough to take it off again!