Cycling UK Forum

Recently finished installing the Tongsheng mid drive motor to an older Orange P7 MTB. There were no instructions in the box, I followed the PDF guide that Woosh bikes provide.

I need to improve the battery mounting before I properly put it through its paces but so far (based on a very quick local test ride) I am pleased with it.

In the box is this spare connector with two bare wires at the end. There's also a 2-way splitter built in to the speed sensor.

Does anyone know what these are for?

The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.

Trikesnbikes wrote:The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.

Thanks, good info!