Dangerous slippy tarmac

Commuting, Day rides, Audax, Incidents, etc.
User avatar
Mick F
Spambuster
Posts: 56367
Joined: 7 Jan 2007, 11:24am
Location: Tamar Valley, Cornwall

Re: Dangerous slippy tarmac

Post by Mick F »

Stevek76 wrote: 19 May 2021, 10:07pm I've no idea why you'd cycle anywhere near as close as a foot from the edge either though. Sounds a like an invitation for punctures. :?
I didn't "cycle" on it.
I pulled up on the side of the road and put my left foot on the kerb.

It was when I was stopping that the wheels locked up. Only just got my foot on the kerb in time.
Dangerous, I reckon.

Had I been going a tiny bit faster and not as quick at putting my left foot down, I'd have been off.
Mick F. Cornwall
ClappedOut
Posts: 585
Joined: 30 May 2020, 12:43am

Re: Dangerous slippy tarmac

Post by ClappedOut »

squeaker wrote: 17 May 2021, 11:58am Meanwhile, elsewhere along the south coast, it's slippery methyl methacrylate that's raising concerns :roll:
https://en.wikipedia.org/wiki/Methyl_methacrylate Mentioned wood in situ is that what they are using instead of tarmac?
Jdsk
Posts: 24876
Joined: 5 Mar 2019, 5:42pm

Re: Dangerous slippy tarmac

Post by Jdsk »

ClappedOut wrote: 24 May 2021, 6:00pm
squeaker wrote: 17 May 2021, 11:58am Meanwhile, elsewhere along the south coast, it's slippery methyl methacrylate that's raising concerns
https://en.wikipedia.org/wiki/Methyl_methacrylate Mentioned wood in situ is that what they are using instead of tarmac?
As above, the surface is probably cold applied MMA, eg:
https://www.hitexinternational.com/prod ... rip-type1/

Jonathan
ClappedOut
Posts: 585
Joined: 30 May 2020, 12:43am

Re: Dangerous slippy tarmac

Post by ClappedOut »

Jdsk wrote: 24 May 2021, 6:04pm
ClappedOut wrote: 24 May 2021, 6:00pm
squeaker wrote: 17 May 2021, 11:58am Meanwhile, elsewhere along the south coast, it's slippery methyl methacrylate that's raising concerns
https://en.wikipedia.org/wiki/Methyl_methacrylate Mentioned wood in situ is that what they are using instead of tarmac?
As above, the surface is probably cold applied MMA, eg:
https://www.hitexinternational.com/prod ... rip-type1/

Jonathan
Still none the wiser Jonathan, so are we saying a tarmac replacement with a dressing of anti skid material as like ice without?
Jdsk
Posts: 24876
Joined: 5 Mar 2019, 5:42pm

Re: Dangerous slippy tarmac

Post by Jdsk »

Cold applied MMA is used on roads and paths because of its antislip properties. (That isn't mentioned in the Wikipedia article but should be.)

I have no idea what happened in this particular situation.

Jonathan
ClappedOut
Posts: 585
Joined: 30 May 2020, 12:43am

Re: Dangerous slippy tarmac

Post by ClappedOut »

Jdsk wrote: 24 May 2021, 6:09pm Cold applied MMA is used on roads and paths because of its antislip properties. (That isn't mentioned in the Wikipedia article but should be.)

I have no idea what happened in this particular situation.

Jonathan
Fair play, the black road covering in Highbridge over the bridge by the service station had an almost sheen to it and I wondered if it was the solvent coming out of the road surface as it air dried.
ClappedOut
Posts: 585
Joined: 30 May 2020, 12:43am

Re: Dangerous slippy tarmac

Post by ClappedOut »

wjhall
Posts: 268
Joined: 1 Sep 2014, 8:46am

Re: Dangerous slippy tarmac

Post by wjhall »

Earlier this century there was a minor national scandal following the discover that the new free draining road surface took six months to develop its nominal friction properties. Until then it was much slippier than earlier surfaces. Various road accidents were attributed to it.
Could there be an element of this here?
drossall
Posts: 6141
Joined: 5 Jan 2007, 10:01pm
Location: North Hertfordshire

Re: Dangerous slippy tarmac

Post by drossall »

That was the kind of impression that I got in my accident described above. But it was never investigated of course to find out, because it was "only" a bike crash.
Post Reply