Holes in carbon forks

Commuting, Day rides, Audax, Incidents, etc.
orangebiker
Posts: 56
Joined: 3 Jul 2012, 1:21am

Holes in carbon forks

Postby orangebiker » 25 Aug 2014, 9:45pm

Just bought a new carbon road bike and noticed that there is are 2 small holes in the forks, one on each side, on the inside, about 2 inches from the hub. Have only ridden it for a couple of miles so I doubt that I have caused the damage especially as the location of the holes is symmetrical - although the shape is different. One is about 2 mm across and is quite deep and jagged. The other is smaller and is regular shaped. Not like a chip. Can't see anything similar on any other carbon forks in the house. Although the holes don't look like they would cause a danger at present, I'm a bit concerned they could indicate a fault in the manufacture and could get worse - probably going to take it back to the shop. Has anyone seen anything like this before?

(Not impressed anyway as the forks nearly fell off after 2 miles - headset hadn't been screwed together properly in the shop. Also there's a clanking from the bottom bracket. Call me old fashioned but I expect to get a usable bike for £1400 and not just something that looks nice....)

User avatar
Audax67
Posts: 4904
Joined: 25 Aug 2011, 9:02am
Location: Alsace, France
Contact:

Re: Holes in carbon forks

Postby Audax67 » 25 Aug 2014, 9:58pm

Jagged holes in carbon are scary. I'd holler.
Have we got time for another cuppa?

User avatar
[XAP]Bob
Posts: 17971
Joined: 26 Sep 2008, 4:12pm

Re: Holes in carbon forks

Postby [XAP]Bob » 25 Aug 2014, 11:06pm

pictures?
A shortcut has to be a challenge, otherwise it would just be the way. No situation is so dire that panic cannot make it worse.
There are two kinds of people in this world: those can extrapolate from incomplete data.

Pandaz
Posts: 116
Joined: 22 Aug 2014, 10:06am

Re: Holes in carbon forks

Postby Pandaz » 26 Aug 2014, 8:58am

I'd take those forks straight back!

Ayesha
Posts: 4192
Joined: 30 Jan 2010, 9:54am

Re: Holes in carbon forks

Postby Ayesha » 26 Aug 2014, 3:02pm

How is the bracket for the front mech held onto the seat tube?
Is it pop rivetted?

That will give a clue to the manufacturer and shop you bought the bike.

orangebiker
Posts: 56
Joined: 3 Jul 2012, 1:21am

Re: Holes in carbon forks

Postby orangebiker » 26 Aug 2014, 8:55pm

forks2.jpg
Right hand side
forks1.jpg
Left hand side

It's a cube bike which I believe is a good make.

User avatar
cycleruk
Posts: 5532
Joined: 17 Jan 2009, 9:30pm
Location: Lancashire

Re: Holes in carbon forks

Postby cycleruk » 26 Aug 2014, 9:06pm

If the two holes are in similar positions then possibly they were part of manufacture.
If you can, go back to shop and check against other Cube bikes.
You'll never know if you don't try it.