Tongsheng TSDZ2 installation

Electrically assisted bikes, trikes, etc.
Post Reply
beagle
Posts: 4
Joined: 28 Aug 2020, 9:51pm

Tongsheng TSDZ2 installation

Post by beagle »

Recently finished installing the Tongsheng mid drive motor to an older Orange P7 MTB. There were no instructions in the box, I followed the PDF guide that Woosh bikes provide.

I need to improve the battery mounting before I properly put it through its paces but so far (based on a very quick local test ride) I am pleased with it.

In the box is this spare connector with two bare wires at the end. There's also a 2-way splitter built in to the speed sensor.

Does anyone know what these are for?

96980939-4218-4DFB-81A7-B2AFA0AABC9E.jpeg

2B777EEE-AA81-4EB3-98EA-8788B491D44B.jpeg
Trikesnbikes
Posts: 12
Joined: 1 Apr 2020, 3:37pm

Re: Tongsheng TSDZ2 installation

Post by Trikesnbikes »

The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.
beagle
Posts: 4
Joined: 28 Aug 2020, 9:51pm

Re: Tongsheng TSDZ2 installation

Post by beagle »

Trikesnbikes wrote:The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.


Thanks, good info!
Post Reply