Recently finished installing the Tongsheng mid drive motor to an older Orange P7 MTB. There were no instructions in the box, I followed the PDF guide that Woosh bikes provide.
I need to improve the battery mounting before I properly put it through its paces but so far (based on a very quick local test ride) I am pleased with it.
In the box is this spare connector with two bare wires at the end. There's also a 2-way splitter built in to the speed sensor.
Does anyone know what these are for?
Tongsheng TSDZ2 installation
-
- Posts: 39
- Joined: 1 Apr 2020, 3:37pm
Re: Tongsheng TSDZ2 installation
The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.
Re: Tongsheng TSDZ2 installation
Trikesnbikes wrote:The splitter is for connecting lights which are then controllable from some of the display/controllers. If the connector on the "spare" cable matches the splitter connection, it is for connecting to the lights.
Thanks, good info!