using a triple shifter for double chainset

For discussions about bikes and equipment.
aljohn
Posts: 59
Joined: 7 Sep 2012, 9:39pm

using a triple shifter for double chainset

Postby aljohn » 22 Jan 2017, 7:01pm

I've been looking to buy (cheaply) a pair of ultegra 10 speed x 2 shifters. I've just spotted a triple pair of 10 speed shifters and I thought.......
I know I can use the triple to operate with the compact chainset, but it seems so easy..... I bet I can cock it up. So, can anyone point out any flaws in my plan, or anything I haven't thought of, please?

Threevok
Posts: 195
Joined: 30 Sep 2016, 3:11pm

Re: using a triple shifter for double chainset

Postby Threevok » 22 Jan 2017, 7:12pm

Not sure about road bukes, but MTBers have been doing this for years. You just set the front mech not to go past the point of lower gear.

Some MTB shifters (such as the SLX ones on my GT) have a switch on the underneath that actually stops it dropping down to the granny ring - changing it from a three speed to a 2 speed. Again, not sure if there is a road equivalent.

landsurfer
Posts: 5228
Joined: 27 Oct 2012, 9:13pm

Re: using a triple shifter for double chainset

Postby landsurfer » 22 Jan 2017, 7:18pm

I did this on my Triban 500 when i changed the original triple chainset for a SPA Compact Double chainset.

You still have the 3 positions available on the lever.
I decided to use the top 2 positions and set the changer stop to prevent the changer moving in case I accidentally changed the wrong way ....
It worked perfectly.
Cost nothing .....
Be More Mike.
The Road Goes On Forever

Giles Pargiter
Posts: 65
Joined: 15 Sep 2012, 11:34pm
Location: N & Mid Wales.

Re: using a triple shifter for double chainset

Postby Giles Pargiter » 22 Jan 2017, 9:21pm

No problem just set the stops suitably, as mentioned. You can even change straight to a triple when you find the range change comes at an awkward speed (especially in traffic) and you wish to try/go back to a triple :D

Norman H
Posts: 952
Joined: 31 Jul 2011, 4:39pm

Re: using a triple shifter for double chainset

Postby Norman H » 23 Jan 2017, 6:39am

You should set it up so that the redundant click is at the low end (small ring) The easiest way is to set the mech to the inner ring using the limit screw and set the lever in position 2 before clamping the cable. If you have the redundant click at the high end (big ring), there is a danger that the mech will hit the screw stop and overshift enough to jam up.

I hope that makes sense.

User avatar
Gattonero
Posts: 3730
Joined: 31 Jan 2016, 1:35pm
Location: London

Re: using a triple shifter for double chainset

Postby Gattonero » 28 Jan 2017, 10:31am

Just a word of advice, with Shimano shifters make sure the cable tension and FD limit screws are setup well. If -when moving from small to big ring in a double setup, the shifter starts to engage the rathet in the portion for a 3rd ring, it may get jammed.
I've seen many shifters being forced and become unusable.
It is by riding a bicycle that you learn the contours of a country best,
since you have to sweat up the hills and coast down them.
Thus you remember them as they actually are...