Cane Creek S6 Headset question?
Posted: 26 May 2009, 6:22pm
Does anyone know if the stainless cartridge bearings from the S6 version will fit the S3?
To my horror I have just discovered that after just 18 months, and little mileage to be honest, the top bearing on my Cane Creek S3 headset is totally shot. Full of bloody water.........
So rather than fit the same normal bearing again, I'm considering upgrading if they will fit.
And before anyone suggests, yes I have mailed Cane Creek direct, but no response.
Of course I could just replace the lot for a decent Hope headset, but I cannot be bothered with the hassle, let alone the cost.
To my horror I have just discovered that after just 18 months, and little mileage to be honest, the top bearing on my Cane Creek S3 headset is totally shot. Full of bloody water.........
So rather than fit the same normal bearing again, I'm considering upgrading if they will fit.
And before anyone suggests, yes I have mailed Cane Creek direct, but no response.
Of course I could just replace the lot for a decent Hope headset, but I cannot be bothered with the hassle, let alone the cost.