Eastwharf Folding bikes?

General cycling advice ( NOT technical ! )
Post Reply
User avatar
tykeboy2003
Posts: 1278
Joined: 19 Jul 2010, 2:51pm
Location: Swadlincote, South Derbyshire

Eastwharf Folding bikes?

Post by tykeboy2003 »

I just bought one on eBay and the first time I unfolded it the latch broke (see picture). Anyone know where I can get replacement parts? Or even where I could get new ones machined?

The seller knew there was something wrong and pointed it out to me but I don't think he knew that it was about to break completely. I'll give him the benefit of the doubt.

The top bit is the adjuster which has right and left-hand threads, the broken one is left-hand. The right-handed thread screws into the piece lower left, the lower right piece goes through it and through lugs in the fame. The two pieces are fixed together with a grub screw inside the barrel which has broken.
Attachments
20141130_214036.jpg
User avatar
al_yrpal
Posts: 12088
Joined: 25 Jul 2007, 9:47pm
Location: Think Cheddar and Cider
Contact:

Re: Eastwharf Folding bikes?

Post by al_yrpal »

A good yacht rigging place might be able to supply something suitable or perhaps something that can be,adapted. This sort of thing… http://www.southernriggingsupplies.co.u ... s-19-c.asp

Al
Reuse, recycle, to save the planet.... Auctions, Dump, Charity Shops, Facebook Marketplace, Ebay, Boots. Old House, and a Banger ..... And cycle as often as you can...... Every little helps!
User avatar
tykeboy2003
Posts: 1278
Joined: 19 Jul 2010, 2:51pm
Location: Swadlincote, South Derbyshire

Re: Eastwharf Folding bikes?

Post by tykeboy2003 »

Even the smallest one of these is much too long I'm afraid.
Stewart H
Posts: 126
Joined: 9 Jun 2014, 9:47pm

Re: Eastwharf Folding bikes?

Post by Stewart H »

Try looking on ebay for rose joints and the hardware that goes with them, you will find a way to assemble what you need.
User avatar
tykeboy2003
Posts: 1278
Joined: 19 Jul 2010, 2:51pm
Location: Swadlincote, South Derbyshire

Re: Eastwharf Folding bikes?

Post by tykeboy2003 »

Post Reply